Ender 5 Pro 360 Degree LED Strip Mount

cults3d

This was redesigned for the Ender 5 Pro due to people requesting it. I only have the Ender 5 Plus, but if the dimensions that were provided to me are correct, this should fit. Please print at your own discretion as I do not have an Ender 5 / Ender 5 Pro. Once people print it and confirm, I will remove this top text. Description below is from the original post, but replacing Ender 5 Plus with Ender 5 / 5 Pro :D. 2021-02-09: Added an extended version to add 100mm to the legs for a request where the direct drive was not clearing the mount. Here is a Ender 5 / 5 Pro 360 Degree LED Mount that I designed. I wanted to utilize the entire LED Strip that I purchased, rather than cutting it short and wasting it. I purchased a 16.4ft (5 meters) LED Light Strip. I printed this in PLA, so I added some aluminum tape on the PLA just to give it a little more protection in case the LED strip generated a bunch of heat (which I probably was ok..). These connect to the frame in the corner with 3 M3*20 screws and nuts. They barely fit, so if you have longer ones, you can use those. The back right corner does not have a screw as the end stop is there, but the back right corner is designed to sit on top of the bracket and has a cutout for the end stop cable. EDIT: Added different variants for the joinbars depending on how calibrated your printer is. Print out the JoinBarMeasuringTool and then use to see which one of these JoinBars to use. I printed these without supports and orientated standing on one of the ends. The dovetail that is on the plate should be able to bridge without issues and the one that is standing up will not need any help. I used Cura to block all areas where supports would be needed. Also wouldn't hurt to put in AntiWarp tabs.