Ender 5 Plus Linear Z Rod Fix -20mm offset

thingiverse

No Support needed, 4 brackets needed for Ender 5-Plus I made this adapter to quickly fix the Z-Rod height on my Ender 5-Plus while using the Mini-Me Mosquito mount to avoid collisions. The BL Touch needs to be spaced down about 15mm to be used in that set up. These adapters allow you to unbolt the linear rod's lower bracket tension bolt and slide them down until they contact the floor surface plane and install these in place of the upper mounts. They press fit on just fine, but I did include provisions for the original bolts to self-tap in for added security. I used ASA because it's what I print with most but I imagine most rigid materials should be fine if not used in an enclosure (avoid PLA for bed heater issues) Be sure to keep the bed at a high height about 40mm from Z-0 to ensure the Z rods stay square during installation - do one bracket at a time. Hope this helps someone out!