Ender 5 Plus Linear Rail Bed Spacer

thingiverse

The Linear Rail Brackets from Ralp57 (https://www.thingiverse.com/thing:4487342) suggest what I felt was an unnecessarily complicated way to raise the Z screw and Z linear Rails. You need to raise the bed when fitting linear rails because the X gantry is higher than stock, this can lead to wobbly screws due to them being too loose. I felt a better approach was to move the bed up, leaving the rest of the printer stock (It's also a lot easier to fit / print :) ). These go under the bed bracket, so you'll need four. It raises the bed height by 10mm. I printed these at 70% in PLA.