Ender 5 Plus filament stand for direct drive extruders (spool holder)

thingiverse

You need to print 4 bottom pieces and 2 top ones. Printing in the defoult possition worked for me just fine. If You have adhesion problems, you may need to print it on the side. Files do account for some tollerances however you may need to tweak it a bit. From my experience you don't need thick walls, about 1mm should be sufficient. Same about infill, dont go to crazy ;) Angles and dimentions are designed to fit stock e5+ frame, 15/500mm pipes and one up to 20mm bar at the top. I wanted to make bottom pieces mutch lower but they interfered with extruder motor. I drop here the fusion 360 file as well. You can find there all the parameters and change them in parameters tab. Unless you go crazy, the model should adjust all angles by its own without breaking. GL!