Ender 5 Plus Cable management

thingiverse

Designed this to keep the wires on the ender 5 plus nice and neat. This is not a flimsy design, they are strong and keep wires well. The pieces attach to the extrusion with a couple screws and t nuts. They are the width of the extrusion so they stay flush. The caps snaps in place tightly so they wont move with vibrations. If you like my designs, please put a like on it so i know sharing my work is appriciated. you will need to print 2 10inch bottoms and 1 7.25 bottom. For the top you will need a 9 a 10 and a 7.25. Use a 10 inch bottom on top and a 10 inch down the side followed by a 7.25 . when mounting the top 10 inch piece leave a little gap to the side from so you can slide the wires going to the stop switch and the motor. snap the 10 inch to to the side bottom than snap the 9 inch piece to the top against the side cover. the last top of course goes on the bottom part. I will not design a box to cover the wires to the electronic case as I plan on incorporating a PID to control a heater. I will upload that one with my heater modification once I have it designed and tested. I printed mine with PETG but you can use PLA if you wish. Print flat, no supports are needed. Step files are included for those that want or need to modify this design. Enjoy