Ender 5 Plus Cable Chain With Mounts

thingiverse

Made this for ender 5 plus to attach cable chain to extruder in a direct drive setup. I could not find anything with key words to find something. So I made it. This is just the brackets to mount cable chain from https://www.thingiverse.com/thing:2920060.. I used version 3 and v2 clip for actual cable chain. Print cable chain per their instruction My mounts I printed at 2. layer with 10% infill with no supports To mount this remove screws from back of extruder and replace with m3 by 40mm screws. You can also replace 2 screws with #6-32 x 3/8.. I did this just to test. The size a bit bigger and wrong thread but still worked.. I use washers to make up space some and was able to get 1-3 small turns out of it which did work for a good while. I since then replaced with proper screws.. As for back part its printed the same and will need 1 t-slot nut to hold it to the rail. In my case I used 26 chain links. I adjusted my back mount to optimal position to get this to work with 26.. But it doesn't matter if you have more.. You could also put back piece any where you want.. So this part is up to you