Ender 5 Plus BIQU H2 Linear rail mount

thingiverse

An all in one BIQU H2 Extruder mount for an Ender 5 or five plus, X and Y end stop mounts are from from a linear rail upgrade kit. I've uploaded a couple remixes, of the Y enstop I think the V2 should be about right as the V1 was too Small Nozzle was at the back end of the bed. Updated May 7th, 2022 to strengthen the BL touch side of the mount as my initial mount had some flex to it. Source: https://www.thingiverse.com/thing:3960105/files 5015 Part Cooling fan duct, I had to extend the screw slots on the mounting bracket. Remixed part included if you choose to use it. Source: https://www.thingiverse.com/thing:4976865 The rest of the mount is pieced together from various other mounts, all bolts used are M3 holes may need to be drilled out for proper fit. Print 100% infill for strength, I've used PLA on this and my Ender 3 H2 mount which is similar. For install slot the belt through the right side with the clip facing into the Vslot of the X gantry. Then run the hot end fan and BL touch wiring in the slot in the mount and tighten the two rear screws. Loosen the X axis belt as much as possible, may need to remove the roller for more slack. And put the left side of the belt through its slot, and then install the top screw on the extruder and the four on the linear rail. Tidy up wiring in the strain relief and install optional cover.