Ender 5 Micro Swiss DD Extruder wire and bowden support

thingiverse

Ender 5 with Micro Swiss DD Extruder...But should work on anything that has the Micro Swiss and needs your cable chain to extend to the back frame. Has hot-end cable stress relief and Bowden tube support. First few versions did not have enough rigidity to take the pressure of the chain for the hot-end, so this one is two piece held together with Screws. Also modified to clear the X-end stop. After install and BEFORE powering up your printer, move your hot-end to the stop and ensure your wheel still properly contacts the micro switch, add clearance if needed, but should work just fine. Printed in PLA which is proving rigid enough, but I am sure PETG would be fine