Ender 5 Light bar clip

thingiverse

Remixed from [Ender 5 Light Mount](https://www.thingiverse.com/thing:3592772) by [xqqqqme](https://www.thingiverse.com/xqqqqme) to mount the [Ender-5 Light bar](https://www.thingiverse.com/thing:3545616) by [derandi3d](https://www.thingiverse.com/derandi3d). Two clips need to be printed, along with two M3 flat head screws and M3 nuts. The nuts go into the clip, while the screw heads fit into the light bar. A version 2 of the clip may be added later, featuring nut holes instead of cylinder head holes. For now, this setup works, so it remains unchanged. Photos show the mount clip in the first two images and a complete installation with the light bar in the remaining shots. Additional lighting was not used, except for the two LED stripes installed in the light bar. As visible from the photos, plenty of light is achieved. Although derandi3d warned against installing the light bar on top, citing a potential issue where the print head collides with the LED bar, I'm pleased with my results. However, I trust derandi3d's expertise and may not be getting the 100% solution with this setup. For those interested in a camera, consider purchasing a PS3 Eye Camera for a low cost (I paid 7 Euros). Check out my [PS3 Eye Camera Mount for Ender 5](https://www.thingiverse.com/thing:4056911) for more information. The advantages of this camera include good results with minimal lighting and a wide angle mode, which I highly appreciate. My prints have turned out subpar due to issues like wet filament or over-extrusion.