Ender 5 LED strip mount

thingiverse

An Ender 5 strip mount for thirteen WS2812b LEDs at sixty LEDs per meter. You will require two M3 T-nuts and two M3x8 screws to assemble it. This design is not perfect, as a few millimeters are lost in the y-direction and it's not perfectly aligned with the extrusion. However, I didn't find this issue bothersome enough to redesign the mount. I am using these LEDs in combination with a SKR 1.3 board and klipper firmware. The +5V and GND pins from the AUX-1 socket are used, while DI is connected to Pin 3.25. The relevant part of my klipper configuration file follows: [neopixel my_neopixel] pin: P3.25 chain_count: 13 color_order_GRB: True initial_RED: 0.0 initial_GREEN: 0.0 initial_BLUE: 0.0 To change the color of the LED, for example to green, you can add this command to your Start/End/Whatever GCODE: SET_LED LED=my_neopixel RED=0.0 GREEN=0.25 BLUE=0.0