
Ender 5 Electronics Box Mount for SKR 1.4, Raspberry Pi 3B+ and DC-DC Buck Converter
prusaprinters
Please Note: The Buck converter that I based this off has a very uncommon mounting pattern, so you will likely need to remix the buck mount to suit your own buck converter.This is a board mount for the SKR 1.4 Turbo, Raspberry Pi 3B+ and a DC-DC Buck Converter to be mounted inside the stock Ender 5 electronics enclosure. The Board uses the four original mounting points of the stock Creality mainboard to secure the mount in position. The bottom right screw position of the SKR 1.4 is positioned directly over the bottom right screw hole of the enclosure, so an M3x5mm Standoff is used in that position. You do not strictly need this standoff if you are willing to leave that corner free-standing without the screw securing it.The DC-DC Buck Converter mount is a separate part as the overall length would be too long for most printers. The rings should slide over the supports for the Raspberry Pi. I used a flat microUSB cable to power the Raspberry Pi, so the strain relief is shaped to accommodate that shape. You may need to remix the part for round cables.The mainboard will be slightly higher than it was when stock, so you may need to use a case extension if you can't find a way to squeeze the cables. This is the one that I used.Required Hardware:1x M3x5mm Standoff3x M3 x 5mm Screw8x M3x10mm Screw4x M2.5x10mm Screw
With this file you will be able to print Ender 5 Electronics Box Mount for SKR 1.4, Raspberry Pi 3B+ and DC-DC Buck Converter with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Ender 5 Electronics Box Mount for SKR 1.4, Raspberry Pi 3B+ and DC-DC Buck Converter.