Ender 5 Desk Lamp Mount - Fits 2020 x 2 rail. (Double rail)

thingiverse

Lay model flat at its base before printing. I required a mounting bracket that would securely support my LED desk lamp. This design fits snugly without sliding or requiring any additional hardware. I also added a spot for a relay to sit and the cutouts in the object serve multiple purposes: saving plastic as well as allowing wiring to be run through it. Feel free to remix this design! I ultimately did not use the pad for the relay, but if you do decide to incorporate it, I recommend raising the walls around it by a few millimeters as it may be too low depending on how tightly the pins are seated under the board. You could also flush cut the pins or screw in a couple of screws to keep it securely in place.