Ender 5 Control Shroud with Pi (separated)

thingiverse

**Update** _(Mar 22, 2021)_**:** Version 2 is now live! Changes in the version are as follows: 1. Rotated ventilation slots on the top of the Raspberry Pi case section to allow one of them to be used for passing through a camera ribbon cable to the connector on the Pi. 2. Enlarged the dovetail and slot while also deepening the angle of the sides of the dovetail to make it a true, non-directional friction fit. 3. Adjusted the cutout for the ethernet port on the end cap as it's currently a bit fiddly and easy to snap when installing. 4. Added a ramp for the SD Card slot to make sliding it into place easier. **Overview:** I liked dgeddings' model that this is remixed from, but like others in his comments was annoyed with the orientation of the Pi in the model. So I separated the Pi enclosure from the LCD shroud and added a dovetail (with stop) to make the entire process tool-less. Otherwise this is the same model as his. One thing of note, I designed the dovetail to flip the Pi around in relation to the shroud but as this is a dovetail, friction should allow it to be installed in either direction. **Notes:** You need to print one of each file ending in *_v2* to get the correct version.