Ender 5 Cable Cover

thingiverse

This is a cover I made to clean up the cables on my Ender 5 Pro. Its made in 2 parts, the outer side (mount) which bolts to the extrusion using 4x M4 bolts and captive extrusion nuts. And an inner side (cover) that then slides over and bolts onto the rear extrusion with 2x M4 bolts. There's a lip to align the 2 sections. I ended up drilling some holes and adding a cable tie at the front to hold the 2 pieces together. If I was to do it again I would make the first outer side section have the top and bottoms attached, so the inner side was just a flat cover. This would make holding the cables inside at assembly much easier.