Ender 3v2 Hex bit Organizer

prusaprinters

This should be a pretty standard print, no supports needed. I printed with layer .2mm layer height with 15% infill but since this doesn't really support weight, you can probably go even rougher or lower infill with no problem. The fit is pretty close but I did add a strip of double-sided tape to the bottom so it doesn't lift up when I try to remove the bits. The smaller compartment in the drawer has always only stored my hex bits, but I've always had to pour everything out of the drawers to get them, so finally managed to design up this perfectly fitting organization insert for this is perfect for me!(Side note, if you don't like how snug it is, you can also place the tools in backwards and it'll be easier to retrieve. If you put the tools in vertically, it will also function as a tool holder while you're working with it!)