Ender 3 Z-axis Camera Mount for Logitech C270 (20mm Longer with cable management clips - REMIX)

thingiverse

This is a remix of the remix by Zotty's "Ender 3 Z-axis Camera Mount for Logitech C270". I adjusted the camera back 2cm due to collision with my x-carriage - this issue is specific to my custom extruder mount, which extends further on the left side. Two versions are provided here; the first is "v2.1" and features a cutout in the side for filament savings, three holes, and cable management clips. This version is recommended if you can work with the three holes, as my camera's cables fit perfectly within them. The second model is simpler, lacking cable management but including all four holes. Both versions have been tested on my setup using a dampener on the X-axis (stepper rotated 90 degrees). STEP files are attached for each version so you can remix it. Print these models with the angled side facing down against the bed and the side with mounting holes perpendicular to the build plate. Supports should only be required if they touch the build plate, as this model likely prints without them.