Ender 3 V3 SE Left side Tray Bin no clip on

thingiverse

This is my attempt at a Better tray...The one in downloaded before was a clip on and kept getting knocked out (very annoying…)so i designed this new model with the cable holder (obviously) loadas of rounded corners for your printers sake… and no supports… This is also slightly widder than the original with the FULL intent of fitting the honeycomb spatula in there…. aldo the bottom has an 8mm Fillet because it was also a PAIN to get small tools out of the old bin… had to use tweezers most of the time…. Anywho hope you all enjoy and share it, please post your photos if you do print it Thanx!!!