Ender 3 V3 SE/KE Cable Holder

prusaprinters

Cable holder for Ender 3 v3 SE. Should also fit KE, but havent tested that.I recommend using Cable_holder_v2.stl, there are 2mm tighter/wider versions if you want.Simple adjustment of the original cable holder by Vally544. It was very well designed, but I think author measured for the cable width higher than at the clip height, and since it gets tighter at the bottom it was too wide to grab the cable tightly in place, at least in my case. Two changes introduced:6mm tighter cable clip1mm wider frame clip (original is super-tight and very hard to remove)Enjoy :)05/01/2024Some of you have complained that the clip is too tight and the cable buldges. For me the it fits perfectly, however if you find the grip too tight I've uploaded version which is 2mm wider, so there's more room for the cable.19/03/2024Since some of you in the comments pointed out that 2mm wider is still too narrow, I've also uploaded +4mm version.06/04/2024Renamed versions to avoid confusion - you can now choose either “standard” or wider/narrower if they dont suit you. “Standard” is old “2mm_wider” now.Category: 3D Printer Accessories