Ender 3 V3 SE Fan

prusaprinters

Made for 5015 blower fans. Dual mount and Single mount options.No additional hardware required, mounts with OEM hardware.No need to relocate BL-Touch.No hardware needed for blower fans. This design does not require you to mount the fans with screws, as it is held in place by a friction fit. However, the screw holes are still included in the design for alternative mounting with screws or even zip ties.Drop-in Replacement.Minimal supports needed and easy to remove. ________________________________________________________________________________________________________________Material: ABS or PETG recommended. Speed: Slower = Better, since model has some overhangs and bridges. Can be printed faster,               but quality may suffer. Default speeds or Slower recommended. Supports: Make sure to enable normal support, and “on build plate only”.                   Only 3 places NEED SUPPORT.  Under the duct inlet on both sides, and in the slot                      shaped hole on the outside of the right fan duct. (See Images for reference). Any                          other supports are up to you.                   Inside the duct DOES NOT need supports and will be hard to remove, which is                           why you should use the normal supports on build plate only.Orientation: As shown above.Layer Height: 0.2mmWalls: 3Infill: 15%Brim: Inner and OuterTop/Bottom: 3________________________________________________________________________________________________________________Note: The less material file is still a work in progress…