Ender 3 (V2) Z motor lead screw coupler and Z motor mount

thingiverse

One of the bolts in the stock Z coupler for my Ender 3 V2 had its head stripped, so I was unable to remove the coupler without destroying it. So I destroyed it, but only after printing this replacement part. Since the diameter of this part is larger than the stock coupler, you will also need to replace the small Z motor mount (using the existing bolts) with the one I have provided, to allow extra clearance. Intended for use with M3 bolts and nuts - you'll need 4 nuts and 4 bolts. The bolts should be 10mm in length (the photo attached has 10mm bolts in the bottom, but the upper bolts are way too long). I printed the coupler vertically with no supports, and the Z motor mount vertically with supports.