Ender 3 v2 Semi-Auto bed-leveler mount for depth / tire gauge

thingiverse

An easy way to get a bed level is to use a tire depth gauge to know the distance of all 4 corners from the bed is the same, there are others like this for other printers but this was designed from scratch because there isn't one yet for Ender 3 v2 and provide a few additional benefits: * Over time PLA will loosen so this has screws that can be tightened to ensure no wobble of the gauge, making the measurements more accurate and allows the gauge to be kept installed during printing without any wobble affecting the print quality * No need to drill holes or open the back or make any change to the gauge, it just slides as is into the mount * Battery compartment easily accessible while the gauge is in place so you don't have to remove it to replace batteries * no support needed to print * uses standard printer auto bed leveler holes so it doesn't block the airway (as it takes the spot of auto level sensor) and can be kept installed while printing