Ender 3 v2 Raised Feet 41mm

thingiverse

###Why? I made cooling modifications to my printer which require me to raise it a bit. It was originally on bricks but that wasn't looking good. So I decided to make my own printer feet. ###Features The printer still makes contact via the original rubber feet, it's just raised 41mm. The feet also do not interfere with any cables or construction located under the printer, since two of their inside sides are flat. I have added the source files. (Solid Edge 2021 for students .par) ###Important **The feet are paired. One foot fits on 2 sides. FL,RR means Front Left, Rear Right. FR,RL means Front Right, Rear Left. *So print two of each.*** ###Supports No supports should be necessary, I did however print with tree supports. The inside of the feet is hollow. And because the print time isn't short, I didn't want it to fail. ###Print time Print time for all 4 feet is about 10 hours with my settings. *see notes* ###Tips -Wait for the bed to cool down, it is way easier to remove the prints. -Clean the bottom of the feet.