Ender 3 v2 Lower Filament Guide

thingiverse

Remix of the Filament Roller by @Holspeed. I loved the design, but not the fact that I had to thread the filament every time. Made a couple of small changes in Tinkercad for the bracket to fully enclose the roller/bearing, and added a filament loading slot at the bottom, and also added a printable pin so that a bolt was not needed. Fits my Ender 3 V2 very snug. When I printed this one, I used a raft, but would not recommend doing that, as it messed up the spacers a little bit. not a big deal as I sanded that part anyway. You will still need the 608 bearing, and when you put the bearing and spacers in place, you will need to flex the bracket a little bit for fitment, just be careful not to spread it too much. When inserting the pin, I recommend using a table or flat surface to press through, so you do not stress the bracket too much.