ENDER 3 V2 LED SUPPORT

cults3d

English Designed for: ENDER 3 V2 (could fit other models if they share same rail and holes). The model fits on the back of the right rail, using the holes that come from the factory. Model advantage: *Does not obstruct mechanisms *Vertical illumination so that the light always illuminates the part when printing without the hotend covering the part. *It can be screwed with 1 screw that comes extra original *Easy assembly *It has upper and lower hole for ventilation of the led. Need: Screw: 2* M4*0.7 screws L=15mm max (one comes as a spare in the printer). Led model: chip5630 "White", 3 segments of 3 leds = 150mm (width 10mm) (see picture). Led protective plate: Acrylic plate 150mm*((15mm (-0.2)) *1mm(thickness) (see picture) Electric wire: bipolar, outer section 2mm*4mm (20AWG 300v 80º) Switch: dimension 13mm*20mm*H=12mm Transformer: 12v 1A (VDC) tip when printing: place the model as designed, use the hole base in the direction to the bed, so that the switch hole is at the top. This is because it is better to make supports on non-usable parts, in order to preserve the tolerances of the led sockets. Note that brackets should not be placed inside where the cables travel, since it would be difficult to remove them. Anyway you are free to choose how to do it. If you, need some special modification, do not hesitate to consult me, if it is within my possibilities, I can do it. English Designed for: ENDER 3 V2 (could be used for other models if they share the same rail and holes). The model fits to the rear of the right rail, using the holes that come from the factory. Advantage of the model: Does not obstruct mechanisms Vertical lighting so that the light always illuminates the piece when printing without the hotend covering it It can be screwed with 1 screw that comes extra original Easy to assemble It has a lower and upper hole for ventilation of the led Need: Screw: 2 * M4 * 0.7 screws L = 15mm max. (one comes as a spare in the printer) Led model: chip5630 "White", 3 segments of 3 leds = 150mm (width 10mm) (see image) Led shield plate: Acrylic plate 150mm * ((15mm (-0.2)) * 1mm (thickness) (see image) Electric cable: bipolar, outer section 2mm * 4mm (20AWG 300v 80º) Switch: measure 13mm * 20mm * H = 12mm Transformer: 12v 1A (VDC) tip when printing: position the model as designed, use the hole base facing the bed, so that the switch hole is at the top. This is due to the fact that it is better to make supports in unusable parts, in order to preserve the tolerances of the led sockets. Note that there are no brackets to be put inside where the cables travel, as they will be difficult to remove. However, you are free to choose how to do it. If you need any special modification, do not hesitate to ask me, if it is within my possibilities, I can do it.