Ender 3 V2 Lead Screw Handle

cults3d

I know that there are a number of these out there but all of them screw into the lead screw. To me, that means eventually turning them will cause them to become loose. So I made this one that uses 1-4 3mm screws to tighten the handle to the lead screw. Length of the screw must be at least 4mm. This will work for any 8mm diameter lead screw or rod. I also didn't add any mounting to 'stablize' the lead screw as I'm not convinced that it is desirable. I didn't clean it up leaving the glue and mistakingly printing with a brim as shown in the picture. The Hex on top is an 8mm. I don't use it but thought perhaps someday to add a decorative piece.