Ender 3 V2 LCD Side Mount

thingiverse

I have my Ender 3 V2 setup so the extruder side is facing me, so having the LCD mounted on the side was better for my layout. I couldn't find anything else that I could use to mount in this orientation, so had a go and custom made this one based off the ideas in the one I am remixing. I didn't use a lot of infill so it is a bit weak as you can see in the photos where it is attached to the extrusion, but strong enough for what it is doing. Also the one I printed I made a mistake and the holes are 2mm too far apart, but that is still enough tolerance for the LCD pins to go in at an angle. This is fixed in the STL, but I haven't printed to test it. Printing vertically requires no supports, but I printed on a raft to provide enough stability as it got to the higher levels.