Ender 3 V2 hot end cooler - 60mm hot end fan, dual 5015 part coolers

thingiverse

**Remixed hot end cooler for the Creality Ender 3 V2** Part list: **dual_5015_fang.stl** Remix of https://www.thingiverse.com/thing:2763931 (V3 dual 5015 fang). Please resize to 10% before slicing. I recommend an initial layer height of 0.12mm and a brim of 5-10 lines. The 5015 fans can be secured by M3 bolts which can also be printed in any color since there is no real force on these bolts. Requires 2 self tapping screws for the 60mm fan. I added support to the overhang which can be removed in the hot_end.skp file if necessary. The STL file is not perfect around the 60mm fan holes but Cura 4.8 can slice it with 0.2mm layer height without any real issues. **ender3v2_baseplate.stl** I designed this baseplate from scratch based on the V2's x carriage plate dimensions. Please resize to 10% before slicing. The base plate uses the long screw for the stock cover for the left hole and the other two holes are M3. I recommend cutting a M3 threaded rod to length or using M3 bolts. The fang mount is also attached with M3 bolts. **60mm_fan_grill.stl** Remix of https://www.thingiverse.com/thing:2802474 (60mm reduced crosshair). I resized the mounting holes to 5.0mm because the self tapping fan screws would not tap into the PLA and the design is quite fragile. Requires 4 self tapping screws. Please resize to 10% before slicing. Optional: **LED_holder.stl** Original part: https://www.thingiverse.com/thing:3130568 (did not change it). After putting the LED in place you can glue it to the fan mount below. **LED_to_fan_mount.stl** Self designed mounting part for holding the LED. Requires 2 self tapping screws. Please resize to 10% before slicing. **hot_end.skp** This contains all Sketchup models. Note that everything is scaled to 100x so that the units are in cm. The gantry model contains the hot end and ender 3 x-carriage plate, the ender 3 V2 plate is a different model clipped inside. Holes do not line up perfectly on the v2's model because I used a test print and then corrected the holes to match.