Ender 3 v2 Filament Spool Holder

thingiverse

My proposal for a filament spool holder based on the original part. Minimum internal diameter of the spool: 49mm. You can leave gap between "cover" and spool or fill it with rubber or thick tape. BOM: - 2x bearing 6906 (30x47x9mm) or 61906 (30x47x9mm) - 4x M4 nut - 4x M4x8 hexagon socket set screw with cone point Printing: - blockade_2 and blockade_2_nut: print with supports (everywhere) - spacer_1 is optional - clean "cover" after printing, especially from the inside (use sandpaper - if necessary) - cover: use "Brim" for build plate adhesion (vertical printing) Assembly: - it is required to cut off blockade from the original model (end of the handle) - cover should fit slightly and rotate with bearings (adjust diameters with sandpaper - if necessary) - bearings should fit snugly on the original holder, use only hands to place them (extra tools are not required) My proposal: print also (mix with) "Ender 3 Filament Roller Guide" https://www.thingiverse.com/thing:3052488.