Ender 3 V2 - Drawer Organiser with tweezers notch

thingiverse

I added a notch to hold my tweezers. See all other settings from original author below. I used tree supports and that seemed to save a minute or two of print time and it wasn't too hard to remove. Just pull with pliers out parallel to the layers. --------------------------------------Evian_Arts-------------------------------------- ''I had enough of the tools rattling each time i would open the drawer and getting all mixed up after i organised them.'' Drawer organiser for the Ender 3 V2: -Will hold all allen/hex keys, wrenches, original bed clamps, 7mm capacity paper clamps and the flashdrive. -needs supports -5% infill is enough -Friction fit (dimensional accuracy can differ per print/printer, i am not to blame if it doesn't fit well) -Bed adhesion not needed yet recommended due to warping (little struts can be used to tape down the print in case of warping)