Ender 3 V2 Direct Drive Cable Guide -thinner, centered, lower zip ties

prusaprinters

<p>I created this remix because the original version was a bit larger than I needed, and I wanted to fit the cables in more snug. The original also broke when I went to attach the zip-ties, one bit snapped off. It was still usable, but I figured I'd adjust a few things.&nbsp;</p><ul><li>Made the cable channel thinner, so it fits just the hot-end wiring and the extruder cable.&nbsp;</li><li>Moved the cable channel into the center of the plate</li><li>Made the screw holes slightly larger, they now fit a M2.5 screw easily (you can see in the photo I used M2.5 nylon screws with nuts)</li><li>Moved the zip-tie holes down a bit and adjusted the overall placement. I left 4 spots for two sets of zip-ties, I only felt two were really required for my setup.</li></ul>