Ender 3 v2 Creality Laser Bracket with CR Touch

thingiverse

I created a bracket to allow for permanent mounting of my Creality Laser module to my Ender 3 v2 which also has the CR Touch Auto Bed Leveling Module installed. The Laser bracket option provided by Creality didn't provide an option for a permanent installation with the CR Touch module installed so I created this one. I am also throwing around the idea of modifying this design so that the CR touch will completely mount to this bracket and will completely remove the need of using the already existing CR-Touch bracket. This mount will make use of the already existing hardware of the CR Touch bracket as well as the screws used to hold the magnets on the Creality Laser module. To install you simply need to remove the magnets on the backside of the Laser Module and set aside two of the screws that were holding on the magnets. Those screws then can be used to mount the laser to the bracket. Make sure you mount the bracket to the two holes closest to the beam end Otherwise your laser module will sit lower than the CR touch probe. To mount the bracket and laser to the Carriage you simply need to remove the top most screw on the existing CR Touch bracket you should then be able to set the laser bracket down on-to the CR Touch mounting screws that should be protruding through the top of the existing CR Touch bracket. You can then reinstall the top screw through the mounting hole on the laser bracket and CR Touch bracket. (Note: Pictured protruding screws are longer than what comes with the CR Touch Kit. I replaced the M3x6mm screws from the kit with M3x10mm so that I would have the option of installing a nut on top of the laser mounting bracket but I found that it's really not necessary. The bracket is sturdy enough without.)