Ender 3 V2 Control Panel Mount Flush w/X Gantry

thingiverse

I remixed WaydeW's mount to bring the mounted OEM panel flush to the X gantry's tensioner and lowered it to clear the underside of the gantry. I also merged the bracket and mount into a single file so you'll probably want to use supports in your slicer. I then added a couple of holes to allow the use of T-nuts for an extra rigid assembly if so desired. My objective was to minimize the width of the overall printer to better fit inside my enclosure, and to reduce the angle of the display as my enclosure has stacked units with the V2 on the bottom. Note that I left the mount face the same as WaydeW's original and found mine was a tight fit to get the display to slide into the slots, but a light sanding of the face standoffs fixed it. I didn't shave the face as I wanted it tight and preferred a couple of passes with a sanding block to ensure a perfect fit and since I saw no complaints on fit with WaydeW's mount I figured it may just be some ringing as I printed it a bit faster than normal.