Ender 3 Thinner and Wider Spool Holder

thingiverse

Hi All, I just recently started drawing some simple stuff on Fusion360. I started with freecad a while ago and made the transition 2 months ago. Anyways, I got some unconventional spool from ebay seller for some unbranded spools yesterday. the ID of the spool is 32mm and doesn't fit the standard spool holder on ender 3. then, I thought I'd just cut the side endstop off of it. then realized my spool was too wide -_- so i made this 25mmOD with 30mmOD endstop and 90mmW spool holder in case anyone needs it. my last print couldn't fit the collar on because the spacing was a little too small to allow for the bracket thickness and i had to sand down some thickness. So i made it a little wider. should work after i print and test today. print with support and 50% infill update 9/11: yup it worked with a snug fit on the bracket. I found the fastest way to print is to use concentric support at 80% and concentric top and bottom layer. infill just line 30% also added 150mmW version update 9/17: !! just noticed today that my spool broke the spool holder where it connects to the bracket. no sure if it is my unbranded filament issue but the cap ripped a layer off. i will be uploading a beefier version (smaller ID) and rec infill from 30% to 50% I'll try upping the extruding temp to 210 and wall count from 3 to 4 as well. update 9/19 I pulled the ID inward for 2mm to make the walls thicker hope this solves the issue