Ender-3 TFT35 E3 V3.0 Cover Remix

thingiverse

I reworked Redkite's E5 slide-on cover to fit the newer version of the Bigtree TFT35 E3 with an additional board under the knob section. To access the cables, I added an opening at the top and created a clearance hole for the 4040 extrusion on the side. The result works well, but aesthetically it could benefit from about 12mm more length along the bottom edge. However, I was hesitant to alter the perfect alignment of the card slots. If I have the time, I might extend that edge and add a snap-catch for the stock metal mount's bottom edge in the future.