Ender 3 spool 45 deg. bracket re locator.

thingiverse

This mounts the spool holder at 45 degrees, close and out of the way at the same time. uses the hardware that you already have on the holder base slides into the t-slots of the base rail. Printing: a little less than 3 hours at the settings below. wit a feed of 55. I printed this at a layer height of 0.2 with 25% infill zig-zag. nozzle 200c build plate 60c. if your first layer isnt just right it can be a bit of tough put on. you can trim the edges and tap in into the t-slots