Ender 3 S1 Pro Probe offset to align with Y axis

thingiverse

Hey Guys, this is probably one of the best upgrades you can do to your S1 prothis aligns the probe with the nozzle on stock hot ends, this is needed for couple of reasons but the most obvious is if you suspect you have a bent Y extrusionthe new offset will be x_offset: -47y_offset: 0Please note that some deviation is expected and you should still check that yours is zero but its my experience that even if this is off by 1 or 2 mm, it makes a big improvement over the stock position. There are two versions, one that can take M3 insert and the other screw in directly. Remember to set your new offset in config.and at least like this model. Like this model, its free