Ender 3 Roller Guide w/ Runout Sensor

thingiverse

(Note: This IS a remix, but for some reason I can't select the originals while uploading. See attributions below) I liked Ryroo211's guide + runout sensor, but preferred 3djpco's runout sensor w/ bearing + ptfe tube. I modified Ryroo211's mount to remove some material, and stuck 3djpco's sensor body on top. It is not a modular print, you'll need supports. I left the tabs on the sensor body in-place due to laziness. The rear one is handy for cable ties. The front one is unfortunately too close to the Z-axis roller to be used as a tie down, though there is no clearance issue on my Ender 3 V2. This re-uses the original Z-axis limit switch, which is an extra part if you've installed a BLTouch (or similar ABL). Also included: * FreeCAD source of the mashup * The sensor ptfe holder, unmodified from 3djpco. * The roller and spacers, unmodified from Holspeed. I recommend reading through the notes on each of the original sources -- particularly 3djpco's runout sensor, where the details of wiring and setup are documented. Ryroo211's guide + runout sensor: https://www.thingiverse.com/thing:4079159 3djpco's runout sensor: https://www.thingiverse.com/thing:4547442 Holspeed's guide (source for wheel+spacer): https://www.thingiverse.com/thing:3052488