Ender 3 Rear Spool Holder straight remix

thingiverse

I liked the original design very much, however since I dont use any cable chains I noticed that the cables were colliding with the spool since it is too much to the "inside" of the printer This remix is pretty much the same design without the lateral bend, thus it goes straight up This way you can assemble the roll to the other side and free the space for the cables Also since you change the spool from the lateral it is much more pratical than when it was from behind the printer I added a little filament guide as improvement but I actually believe it is not needed, I didn't notice any problem when printing without it Also if you are interested in the blue spool roller in the picture you can find them here: https://www.thingiverse.com/thing:4804090 Edit 20/04/2021: I added the stl for the filament guide I made. I used an extra pulley bearing I had around for it