Ender 3 rear mount All In One electronics case

thingiverse

Dual Z notes: Latest Left AIO Lid with Dual Z Motor notch file is of course for those running the Creality Dual Z motor kit or for those wanting to use this Dual Z kit. For those not running Dual Z and not wanting too, use file Left AIO Lid with Supports Notes about Cable Chain, the cable chains I used will be uploaded separate, however I had to modify the rail mounts for my cable chains so be aware of your cable chain mounting with these files as you may need to modify or relocate them. I wanted to have more room for cable management in the case, and since I already made riser feet and a rear mount PSU system I had an extra 15mm in height by lowering the bottom of the case, then I thought I might want a fan in the lid, (because hot air rises) so I added a raised section to the lids. Increased lid section height adds around 10mm and the top of the finished lids sit just above the side rails when installed. I also added center rail supports because the center of the original rear AIO I printed by Teaching Tech would sag on me. I am uploading the riser feet and rear original Ender 3 PSU mount so you can do the same or similar. Remixes are welcome. I would like to thank Teaching Tech for the original design, starting with that saved me a lot of time and was almost exactly what I was looking for. This overall is ready to go, however I am still working on some tweaks. I have the Creality Dual Z upgrade, I needed to raise the position of the left side Z motor a few mm's to slide the left lid all the way in as the raised section of the lid would run into the electrical connector port of the motor and the wires were bent pretty sharp to make the slot around and between the connector and raised portion of the lid. I made a few support pillars for the lids as I added some bracing for strength in the under side of the lids, The pillars were cut off by .2 mm and lowered to plate height, however the support pillars so far have come out still attached and not easy to remove. Other than the 5 support pillars I haven't needed any other supports for the lids while printing right side up, the way they should be in download.