Ender-3 PSU dummy model

thingiverse

To relocate the PSU on my Ender-3, I required an expedient model of the PSU itself. The outside dimensions must be precise, and since I'm likely to mount it upside-down from the Y-axis rail, the hole pattern on the bottom is accurate as well. Everything else was hurriedly done, so make sure to verify any other dimensions you take from this model. I also modeled the cover separately, in case I decide to swap the fan with something quieter. Since upgrading the board and drivers, the fan on the PSU has been the loudest part of the entire setup. I've included a compressed folder with all the components I used, but again, I didn't spend a significant amount of time ensuring they're ultra-accurate. Buyer beware.