Ender 3 Pro - Station (LCD/Pi/Drawer Space/Steampunk Gears)

thingiverse

I was determined to create something unique for my Ender 3 Pro with a steampunk twist and personalization options, so I finally combined multiple models to achieve this. As one of my first remixes, some modeling issues may arise, but I successfully printed it without any problems. This design boasts several features: 1. Personalize it! Attach steampunk gears wherever you prefer 2. Ample space for a Raspberry Pi in the case 3. Simplified Raspberry Pi port: Only power is required 4. Deeper than the original design to accommodate the LCD plate correctly (this may depend on how your LCD plate has been bent by Creality) 5. The left side has been modified to accommodate dual drawers (either the original or my remix) Please be aware of the following warnings: 1. Fitting the Pi into it is a tight fit, so handle with care 2. To secure the PI, attach a screw and nut only at the front left corner 3. You cannot place gears everywhere; one or two holes are directly against the LCD electronic board, leaving insufficient space 4. This design requires extensive support; be prepared to waste some plastic To print this case: 1. Ensure it is on the side (gears hole on the bed) 2. I strongly recommend using Cura Tree Support 3. Refer to my support settings in the screenshots if needed 4. Due to the unpredictable nature of printing, slice until you achieve the correct support for port holes (check screenshot)