Ender 3 Pro Simple Front Drawer and Rear Tray

thingiverse

Yes, ANOTHER drawer/tray for the Ender 3 Pro. I was looking for simple yet functional front and rear drawers/trays (right side) for my Ender 3 Pro and while there are many, many drawers and trays available for the Ender 3 Pro, the one that caught my eye for perfect functionality and simplicity was Holspeed's front tray design (https://www.thingiverse.com/thing:2957317). One minor issue that I had with it was that the supplied cutters did not fit into the tray so I enlarged the tray to fit under the Y-axis extrusion and strengthened the left side supports/slides - now the cutters fit perfectly and slides out enough to get the tools when required. I also remixed the original front drawer to make a rear tray for the same printer with a cutout to miss the Y-Axis endstop/limit switch assembly and a cutout for the power cable. To fit the front drawer just temporarily remove the control panel and slide/massage the drawer into place. To fit the rear drawer you will probably need to remove the Y-axis limit switch. Just remember approximately where the switch was so that you can re-install it in the correct position. These both fit perfectly on my Ender 3 Pro that has spacing of 105mm between the Y-axis extrusion and the right side horizontal extrusion.