Ender 3 Pro SD Card Extender

thingiverse

I encountered a frustrating issue with the Ender 3 Pro microSD card location. My computer came equipped with an SD card reader but lacked a MicroSD card reader, leading me to use an SD card reader for the Ender 3 and acquire a MicroSD to SD adapter so it wouldn't obstruct the printer's bed. I printed this project using PLA on standard settings without any special requirements. - Layer height: 0.16mm - Initial layer height: 0.3mm - No supports were added - A skirt was printed but no raft was used - The extruder temperature was set to 200 degrees, while the bed temperature was set to 50 degrees - The top and bottom consisted of six layers each, with three wall lines in between - Infill density was set at 20% The result was a print that took 1 hour and 26 minutes to complete, using approximately 10 grams or 3.4 meters of filament. The microSD card holder fits snugly onto the end of the frame where the two screws for the electronics case are attached. I utilized Commando Picture Hanger strips to secure it in place, finding them more than strong enough to hold when inserting the SD card into the reader. https://www.amazon.com/Command-Picture-Decorate-Damage-Free-PH206-14NA/dp/B073XR4X72