Ender 3 Pro Rail Cover **updated to v3**

thingiverse

If you appreciate this design and want to express your gratitude, consider supporting me by sending a tip! Thank You very much! **UPDATE 02/22/2020:** Woohoo! 1000 Collects and 700 likes! I am thrilled with the response. If you have an idea for an Ender 3 (Pro) thing, feel free to share it in the comments! **UPDATE 01/19/2020:** I've updated to v3. Changes include: * Moving the optional embossed Creality dragon logo to the top * Tightening the fit * Slimming down the design, reducing the height by ~2mm * Removing the initial version due to possible interference with the bed **Advise:** You can print it in the given position without support - it will cause slight spaghetti at the clip, but that doesn't really matter, as it fits tightly nonetheless. However, you can use supports of course (only for horizontal parts), so that you only need supports in the clip itself, and the rest should print fine. Alternatively, you can print it with the top facing down, no supports needed then. **UPDATE 03/18/2019:** I've added v2 of the cover here too, as one user mentioned that the original cover blocks the bed from moving all the way. I rechecked it with my printer and it blocks it by maybe 2mm, so it may only interfere when you use ALL of your bed surface to the last mm (which is always a bit risky). There's a new version out which is a bit shorter and should not interfere with the bed at all, has nicer edges and the logo on the front, not on the top. You can find it here: https://www.thingiverse.com/thing:3490301 I tried some of the covers here on thingiverse - those that slot into the v-slots. For them, I had to disassemble the belt tensioner and both of them broke during assembly. So I decided to create my own cover and make it a simple clip-on that you just have to print and snap on the white axle without disassembling the belt assembly. And of course, I wanted the cover to look good and match the angular style of the printer. There is one version with the Ender Logo (quite difficult to print in this small dimension) and a blank version included. I strongly recommend printing it with 100% infill to get maximum strength, especially for the snap-on clamps. **My other designs for the Ender 3 (Pro):** Octoprint Raspberry Touchscreen Box Remix https://www.thingiverse.com/thing:4062202 Flexible Filament Extruder Remix https://www.thingiverse.com/thing:4005786 40mm Fan Duct https://www.thingiverse.com/thing:3949647 Magnetic Tool Holder https://www.thingiverse.com/thing:3508230 Extruder Knob https://www.thingiverse.com/thing:3475324 Spool Inverter https://www.thingiverse.com/thing:4196391