Ender 3 Pro Power Supply Mount

thingiverse

I created this design to fasten the power supply to the outer side of the extruded rails. After upgrading my printer with dual Z motors, the PSU couldn't be attached to the vertical Z supports. I made this design to fit the base of the Meanwell PSU and made room for the cable to go from the bottom and up the backside of the PSU. You will need 4 M4 screws, T Nuts and Washers to attach this part to your printer. I also offset the inside faces for a little looser fit. The one I made was very tight and hard to remove once the PSU was installed.