Ender 3 Pro Power Supply Fan Silencer - HD

thingiverse

This was redesigned due to the artifacts on the original STL and exported with the highest possible settings. In addition, the fan screw holes are over sized for a correct through fit and the flat head screws should be flush with the surface. Also, the inner structure has been simplified so the baffles don't extend the entire length of the duct. This design was based off of the Ender 3 Power supply fan silencer by RohaniSousBois. https://www.thingiverse.com/thing:3328495 Notes on installing the part 1. Take off only one screw from the power supply fan and use it to screw the printed part in place. 2. Pivot the printed part to reach the second screw. 3. Take the second screw off and screw it back with the printed part. The fan should always be held by one screw otherwise it will fall into the power supply case. IMPORTANT : Jun 30, 2019 It looks like on the newest model uses a 9.64mm ATX fan screws rather than 11.77mm which is the standard. If you are making this for a 2019 model you may need to get some PC fan screws since the ones provided will be too short for the new shroud and the fan.