Ender 3 Pro Mean Well PSU Mount

thingiverse

The intent behind this design is the same as the original: to mount the PSU to an Ikea Lack table as part of an enclosure. Attach the mounts to the PSU using M4x8mm screws. NB! Depending on where you want to mount your PSU, you may need to mirror the parts along the X axis. Pay close attention to the screw hole location! Changes from the original include: - Top mount resized (enlarged) to fit the Mean Well LRS-350-24 PSU for the Ender 3 Pro. Note: as seen in the photo, I'm using [this PSU mod](https://www.thingiverse.com/thing:3206719) -- but it isn't required. A stock PSU will also fit just fine - Increased mount points from 2 to 4. Since the Lack table is made of essentially thin cardboard, more mount points should help it hold over time without stripping out - Added a top "spacer" to help square the PSU against the table (see photo) - Mirrored both parts along the X axis for mounting the PSU at the rear-right corner of the enclosure. Be careful to note this difference.