Ender 3/Pro Left side Pi & 5" LCD Mount

thingiverse

UPDATE 02/15/19: After several test prints, I've found the best orientation for it. This is going to be a long print because of the need for supports. I suggest using "supports everywhere" because some of my lines and holes for the pi ports didn't come out right; I had to trim them, but it's good enough for me. I also highly recommend you use a Z Distance of 2mm for your supports; two of my prints were trash because I couldn't remove the supports. This print is now ready for release; feel free to remix it and tweak it - maybe I'll like yours better and link it here!! ________________________________________________________________________ FIRST PRINT: As far as fitment goes, everything fits great. With my current settings listed, the support roof didn't want to come off, and I even had to cut a piece off by the mounting holes; I suggest you use more walls. I will be reprinting this piece with more walls. ————————————————— Raspberry Pi W/5' TFT LCD holder for the left side is in progress - I'll remove "in progress" status when it's finished printing and tested. PRINT IN CURRENT ORIENTATION I use a 0.6 nozzle. Layer Height: 0.36 Initial Layer Height: 0.1 Infill Line Width: 0.6 Wall Thickness: 2.4 Wall Count: 4 Top/Bottom Thickness: 1.08 Top Thickness: 1.08 Top Layers: 3 Bottom Thickness: 1.08 Bottom Layers: 3 50% Infill Line Pattern 220 Nozzle 60 Bed 100 Flow 5mm Retraction (Direct Drive Mod) Speed: 50 Combing Mode: All Avoid parts when traveling: ON Avoid supports when traveling: ON Z Hop When retracted: ON Z Hop only over printed parts: ON Supports: Everywhere Angle: 50% Zig Zag Support Roof: 2mm Support Z Distance: 2mm Skirt: 5mm