Ender 3 Pro LED Low Light Strip

thingiverse

I previously built a bracket for a Light, but it just didn't illuminate under the cross bar. This will take a strip of 6, 10mm wide LEDs (as multiples of six need to be used with this set of lights). I chose 24 V so I can wire them into the existing system with out the need for a plugged in power supply. This will fit behind the extruder fan enclosure with or without the BLTouch installed. If you have the BLTouch this goes in front of the BLTouch mounting bracket and behind the fan shroud. The view tunnel will easily accommodate the 20 ga (these 6 LEDs draw only about 50 milliamps) wire up through the BLTouch wire loom down to the power supply. It has to be slim so it won't touch the bed while leveling or printing the first layer.