Ender 3 Pro LCD Knob Cover

thingiverse

I was searching for a good replacement of the stock LCD knob. There are a lot of nice designs around here BUT (and don't get me wrong for this) most of them felt very light or small and out of place (maybe a bit loose too). My favorite designs here are the ones that utilize the stock knob with an over-cap. So I made one with a single bump and one with triple bump (similar to Prusa's but with a different angle). IMPORTANT: this is made with a very tight fit in mind so make sure your printer is properly calibrated and has the expansion calculated. Also print with the existing .STL orientation and use support (for better finish).